The anode plate of the electrostatic precipitator is the core component of the electrostatic precipitator, the anode plate acceptance criteria: straight, high strength, stiffness, not easy to distort. Aftermarket: shelf life of deformation. ESP anode plate made common standards board for C480mm plate with Z-385mm board, the company with a multi-function two sets of positive plate mill, complete mold. Produce C480-type Z385-shaped, ZT24 type on the anode plate (change rolling roll can be). 


 Product Name: plate ZT-24 big wave 
 Material: carbon steel ST12 
 SPCC 
 304 Stainless Steel 
 1Cr18Ni9 
 Thickness: carbon steel 1.5 
 1.2 
 Stainless steel 1.2 


 Installation, adjustment and test run 
 1, install the lower section. Bucket elevator to the lower part of the bearing surface to ensure that after bolt fastening is located in the horizontal plane based on correction. On the face and the horizontal plane parallel to the degree of tolerance of 1/1000. 
 2, according to the mark in order to install the intermediate casing, the connection of the chassis allows the pad into a waterproof canvas or asbestos with to ensure the sealing and adjustment. Requirements of the centerline of the lower part and the central case and strive to in the same vertical line, the vertical deviation in a 1000mm length should not exceed 1 mm, total height of the cumulative deviation should not exceed 8mm. The dual-channel chassis also note that the two-channel chassis flush. 
 3, in order to prevent the shaking of the elevator, Central must prevent the offset of the bearing device, the spacing of the points of support not more than 8m, the top of the points of support as close as possible to the head. Bearing devices do not restrict the hoist in the vertical direction of stretching. The dual-channel intermediate casing at intervals of 4m to use even board the two channels join together to enhance stability. 
 4, install the upper section of the drive, install reducer reducer sure to carefully read the instructions. Reducer to add a little industrial gear oil (see reducer manual) 
 5, the spindle with the lower part of the axis in the same vertical plane, the two axis lines should be horizontal parallel. YY drive low-speed shaft and the spindle and strive in the same center line, the maximum parallel offset shall not exceed 0.1mm, the maximum axis angle shall not exceed 
 6, the final installation and operation section. Chain bucket elevator chain should be optional, parallel to the two chains of equal length. The running part of the installed closer to the device after the rest of the trip is greater than half of the whole trip. 
 HL dual-channel hoist installation or adjustment of the chain, you need to lift the heavy steel tanks closer to the sprocket group, you can use the central case of hanging. The method is: Open the lower part of the district, the cover section in steel tanks to hang a small lifting hoist to lift the sprocket group. 
 More high-quality equipment impeller feeder